Point Level Sensor uses patented
Technique To provide Self-Diagnostics
Monitor Technologies Wins at the
5th Annual Horizon Interactive Awards Competition
Elburn, IL -- It seems as though some of the lowest
cost devices, such as a point level sensor used for
detecting the high level status in a vessel, can cost
you the biggest headache if it fails, not to mention
clean up and lost production costs. Monitor Technologies
is pleased to announce that the SafePoint(R) point
level sensor incorporates the patented use of Hall
effect technology, dual outputs and industry leading
features to continuously monitor it's status and the
presence and absence of material. If a fault condition
is detected an independent relay changes state to indicate
a failure condition. No longer do you have to wait
for a problem before learning of a sensor failure.
This can save you time and money.
The SafePoint level sensor is a fail-safe level sensor combining the proven aspects
of rotary paddle technology and state-of-the-art Hall effect sensing to reliably
detect the presence/absence of process material at the point of installation,
as well as to detect electrical and mechanical failure modes that might keep
the unit from operating properly. The SafePoint is a relatively low cost fail-safe
level sensor, under $300 US, with state-of-the-art electronics and patented technology,
industry-leading screw-on/off cover, two conduit entrances, local indication
and separate outputs to continuously monitor it's health status as well as the
presence and absence of process material. It is designed specifically for applications
with powders and other bulk solids, can be provided with approvals for Class
I and II hazardous areas and carries CSA (for North America) and ATEX certifications
for these environments.
Monitor Technologies LLC is a leading supplier of level, flow, particle emission
and aeration instrumentation for the worldwide powder and bulk solids market.
The experience and market knowledge gained over five decades has earned Monitor
a reputation for providing high quality and reliable product solutions. Monitor
is located in Elburn Illinois, give us a call today and let us put our creative
solutions to work for you!
For more information refer to www.monitortech.com or contact Ms. Emily
Jones at 1-800-766-6486 (630-365-9403).
The TrueCap® Model MK-2
RF Capacitance point level probe is designed to provide a superior
and stable sensitivity threshold making it suitable for a variety
of powder / bulk solids and some liquid or slurry applications.
Advanced features of the Model MK-2 include: > Automatic immunity to material build-up on
the probe by its driven shield design > Push-button calibration > Enhanced temperature compensation > Maximized reliability via smart sensing algorithms
like “self-validating” fail-safe protection > Visible status LED on ordinary location units > Versatility through a variety of configuration
options including: hazardous location version, split architecture
design, quick-connect process connection, stub probe, cable extensions,
solid extensions, Nylon® probes, Ryton® - equiv. probes,
A practical application for the TrueCap would be to use this level sensor where
a residual material build-up on a different sensor would cause a false material
Principle of Operation for the TrueCap RF Capacitance Level
The vessel wall and the active probe element establish an impedance reference
between each other when exposed to air which has a dielectric constant of 1.
When materials with a dielectric constant greater than 1 are in close proximity
to the probe, the impedance of the sensing field between the sensor and the vessel
wall will change. Once the amount of change exceeds a threshold that was electronically
determined during the calibration process, an output relay will either be energized
or de-energized depending upon the position of the fail-safe selector on the
probe’s electronic circuit board. A change of as little as .5 pico-farad
is all that is necessary for the probe to sense the presence of material.